Make your own bracelet of the best Shambala beads!

SHAMBALA BRACELET SET

Step 1
You need scissors, glue, and tape (not part of the set).
1. Cut 50 cm of waxed thonging and 100 cm of cotton yarn.
2. Place the waxed thonging on a surface and tape it down 11 cm from the end.
3. Choose your favourite beads and shove them on the waxed thonging.
4. Now tape the lower, open side down, leaving the beads some room for movement.
5. Place the cotton yarn under the waxed thonging so that it is of equal length on both sides.
Step 2
See the figure on how to make a macrame knot
1. Place the yarn under the thonging.
2. Curve the left yarn under the thonging.
3. The right yarn is now running over the waxed thonging and under the left yarn. Pull from both ends of the yarn to make a knot around the waxed thonging.
4. Mirror the movement to make the next knot (opposite directions).
5. Make a total of 16 knots.
bracelet)
Step 3
1. After you have finished 16 knots, add the first bead, and make two macrame knots (see step 2) to attach the bead.
2. Add the next bead and repeat step 3.1.
3. Repeat until all beads are attached. Now, make another 16 macrame knots and finish the work with a regular knot.
Add some glue to the knot to prevent it from untying and let it dry.
4. Cut off the extra yarn.
Step 4
1. Make sure that there is 11 cm of waxed thonging on each side of the beads. Put a pearl on each side of the yarn to act as a stopper.
2. Now close the bracelet. Cross the ends of the waxed thonging and put them in a parallel position. Tape them down.
Step 5
1. Cut 50 cm of yarn and place it under the waxed thonging by the upper tape. Make sure that the yarn is of equal length on both ends.
2. Make 14 macrame knots around both waxed thongings, and attach both ends, like before.

ROUND LOOM (Friendship bracelet)
1. Cut 16 threads, 50 cm each. To get the pattern you want, choose the colours with the help of the loom. For example: